Quicklabel Kiaro! Uživatelský manuál Strana 147

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 166
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 146
Kiaro! User Guide 131
8
UW-5 Unwinder
Before Installing the Unwinder
Before installing the unwinder, observe the following precautions.
No unwinder feet should float. The unwinder must be held level constantly.
The unwinder must be installed on the same plane as the printer.
When placing the unwinder on a desk, table, or other similar surface, it must be
sturdy and stable enough to support the weight of the printer and the unwinder.
Do not turn the unwinder mandrel by hand to unwind the media. Turning the
mandrel by hand can result in unwinder damage.
Installing the Unwinder
1 Ensure the power switch on the unwinder is in the off position.
2 Arrange the unwinder and brackets as illustrated below. Refer to this illustration
through the installation process.
3 Insert the tabs from bracket U into the slots on bracket R. These two brackets will
later be used to position the Kiaro! printer.
4 Fasten the R-U bracket to the U bracket using the supplied thumb nuts. Ensure the
threaded pin is centered in the adjustment slot.
R
R-U
U
UW-5
Zobrazit stránku 146
1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 165 166

Komentáře k této Příručce

Žádné komentáře